AMERICAN MADE!

The difference between this Model 2 carrier and our Model 1 carrier is: 1. Adjustable cradle, goes up and down to accommodate a bow or a long gun, even a particularly odd shaped rifle stock or scope. 2. Rear anti-vibration support brace has been added. Ezgo Golf Carts have thin floors and need this extra support 3. Lower butt brace at bottom has been added so weapons don't vibrate on base plate. The gun butt never touch the floor, thus no vibration and no worry over knocking scope cross hairs off center

We use the same ozone protected, tight rubber straps on this gun rack that we use with our ATV Gun & Bow Carrier

Has angled, user-friendly tilt on stalk

Whether you purchase our Model 1 or Model 2, both are better built and ergonomic formed better than anything on the market, PLUS they have a thick rubber coating over stout steel,plus, our racks are American Made!

INSTALLATION DIRECTIONS: Simply decide where you wish the carrier to be located on your floorboard. Place down the base plate with pre-drilled holes. Simply place drill bit through pre-drilled base plate holes and drill three holes through your floorboard. Push bolts through and tighten

When you don't want the carrier inside the cab, you can easily remove the stalk itself and leave the bolted down base plate by a simple set screw